Daniel Island was built all at once, so its appliances age in cohorts. The builder-grade sets from the early 2000s are on their second failure and the newer machines along Seven Farms Dr fail on boards and sensors, not belts. We come across I-526 from West Ashley in about 30 minutes, coordinate with the HOA or rental manager, and quote every repair in writing.
Tap a machine for symptoms, the procedure and local notes.
The run to Daniel Island is I-526 from West Ashley, across the Ashley and the Cooper and over the Wando, about 30 minutes to the Seven Farms Dr exit. From there the island is compact: Seven Farms Dr and Daniel Island Dr carry us to the condos and townhomes around the town center, River Landing Dr to the buildings along the Wando, and the residential streets around Smythe Park and Pierce Park out to the golf-course side. Most multi-family buildings have controlled entry, and many units are managed from off the island, so we ask for the gate code, the manager’s number and access notes at booking. There is no bridge fee and no travel line on the invoice.
Nothing on Daniel Island predates the late 1990s, and that shapes the work. The first wave of houses came with matching builder-grade appliance packages, and those refrigerators, ranges and dishwashers are now at the age where the second major part goes. The condos and townhomes run stacked laundry pairs in closets and compact dishwashers under short counters. The newer construction and the renovated kitchens near the Daniel Island Club carry built-in lines, panel fronts and induction cooktops. Across all of it the failures are electronic: inverter compressor boards after a storm, washer pressure sensors, dishwasher door latches the board stops trusting, oven control boards that lose a relay. Charleston Water System supplies the island, so scale is rarely the story. The meter is.
| Appliance | What we see most here |
|---|---|
| Refrigerators | Inverter boards on newer French-doors after power blips, evaporator fans, built-in columns in renovated kitchens, warm units reported by a manager. |
| Dryers | Stacked pairs in condo closets with short vents that clog fast, thermal fuses, drum rollers on the early-2000s builder sets. |
| Washers | Pressure sensors and door locks on front-loaders, drain pumps with debris, stacked units that were never leveled in their closets. |
| Dishwashers | Compact and panel-front units, door latches with worn strikes, drain pumps, control boards on newer models. |
| Ranges & ovens | Control boards and bake elements on electric slide-ins, induction cooktop zones, weak oven igniters on the gas ranges near the club. |
| Ice makers | Board-controlled modules on inverter refrigerators, weak fill valves, frozen fill tubes in door-mounted units. |
Stacked pair in a third-floor condo closet, dryer running warm but never dry. The vent is only six feet long and packed solid with felted lint at the wall connection. We clear it, meter the element and thermostats, check the rollers while the cabinet is open, and leave a written summary for the HOA manager.
A tenant reports the refrigerator cool but not cold and the property manager books from off-island. Inverter French-door, four years old, a storm last week. The board output to the compressor is wrong on the meter; the compressor itself is fine. One written number to the manager, approved by text, board installed the same visit.
Front-loader in a townhome throws an unbalanced-load code on every spin. The owner has been rearranging towels for a month. Two suspension shocks have collapsed and the tub is hitting the cabinet. We replace the set from the van, level the machine on its pedestal, and run a full spin before leaving.
$99 diagnostic, inside the repair · up to $20 off online
Daniel Island washers are mostly front-loaders, many of them stacked in condo and townhome closets along Seven Farms Dr, and they fail on the electronic side: a pressure sensor reading wrong, a door lock the board will not trust, an unbalanced-load code that is really a collapsed shock. We meter each of those before naming a part and put one number in writing. The $99 diagnostic is inside that number; decline the repair and $99 is the whole bill.
| What you notice | What it usually is | What we do |
|---|---|---|
| Error code, cycle stops | Pressure sensor, door lock, or a drain pump with debris that the board reports as a fault | Read the board history, meter the part it points at, confirm the sensor is not the failure |
| Unbalanced code every spin | Collapsed suspension shocks or a stacked pair never leveled in its closet | Replace the shocks from van stock, level the machine, run a full spin |
| Drum of water, door locked | Drain pump blocked or failed, or a kinked drain hose behind a stacked unit | Empty the drum, open the pump housing, check the hose route, meter the pump windings |
Book washer service in Daniel Island → · Full washer repair page →
$99 diagnostic, inside the repair · up to $20 off online
Condo dryers on Daniel Island have short vents, and short vents clog faster than long ones because the lint has nowhere to spread. The stacked pair in a Seven Farms Dr closet stops heating, the thermal fuse has opened, and the six feet of duct behind it is solid. Single-family houses around Smythe Park run the longer upstairs vents that pack with humidity. Either way we meter the heat source, measure airflow and quote in writing, with the $99 diagnostic inside the number.
| What you notice | What it usually is | What we do |
|---|---|---|
| Warm but never dry | Felted lint in a short condo vent, a crushed flex hose behind a stacked unit, or a weak element | Measure back pressure at the exhaust, clear the connection, meter the element |
| No heat at all | Tripped thermal fuse on electric, failed igniter or gas valve coils on gas, or one leg of 240 volts lost at the breaker | Check the wall supply, meter the fuse, element or igniter, then the vent |
| Thump or squeal from the drum | Worn drum rollers or idler pulley on an early-2000s builder set | Spin the drum by hand, replace the worn rollers and belt while the cabinet is open |
Book dryer service in Daniel Island → · Full dryer repair page →
$99 diagnostic, inside the repair · up to $20 off online
A Daniel Island refrigerator that is cool but not cold after a summer storm is almost always an inverter board, and the meter is what separates the board from the compressor behind it. Built-in columns in the renovated kitchens near the club and the standard French-doors in the condos get the same sequence: temperatures, coils, fans, board output, compressor windings. Warm refrigerators get a same-day window. One written number, the $99 diagnostic inside it, and $99 is the whole bill if you say no.
| What you notice | What it usually is | What we do |
|---|---|---|
| Cool but not cold, faint clicking | Inverter board or main board on a newer refrigerator; start relay on an older builder set | Meter the board output and compressor windings before naming the part |
| Fridge warm, freezer cold | Evaporator fan stopped or defrost failure with the coil iced behind the freezer panel | Pull the panel, meter the fan and defrost heater, clear the ice, restore airflow |
| Water under the crisper drawers | Frozen defrost drain sending melt water forward, or a leaking fill valve behind the unit | Clear the drain, check the valve and line with the refrigerator pulled out |
Book refrigerator service in Daniel Island → · Full refrigerator & freezer repair page →
$99 diagnostic, inside the repair · up to $20 off online
Electric slide-ins and induction cooktops dominate Daniel Island kitchens, with gas ranges and pro-style lines in the houses near the club. The electric failures are control boards, bake elements and cooktop zones; the gas ones are weak oven igniters and clicking spark modules. We put a thermometer in the oven and a meter on the part at the same time, and the written number reflects what both found. The $99 diagnostic is inside that number.
| What you notice | What it usually is | What we do |
|---|---|---|
| Oven never reaches temperature | Bake element with a hidden break, drifting sensor, or a relay board that quit on electric; weak igniter on gas | Meter the element and sensor against a thermometer, clamp an ammeter on the igniter |
| Induction zone dead | Zone generator or control board on the cooktop, sometimes a cooling fan that failed first | Meter the board and each zone, check the fan, quote with the unit’s age in mind |
| Display dark after a storm | Control board or oven thermal fuse taken out by a surge | Meter the board inputs and fuse before ordering; quote in writing |
Book range service in Daniel Island → · Full range, stove & oven repair page →
$99 diagnostic, inside the repair · up to $20 off online
Daniel Island dishwashers are compact in the condos, panel-front in the renovated kitchens, and quiet enough everywhere that a weakening wash pump goes unnoticed until the plates come out dirty. Door latches are the other common call: the strike wears, the board stops reading the door, and the cycle never starts. Charleston Water System water is not hard, so scale is seldom the answer. We run a test cycle, meter the pumps and latch, and quote in writing with the $99 diagnostic inside the number.
| What you notice | What it usually is | What we do |
|---|---|---|
| Won’t start, lights blink | Door latch or strike worn so the board never sees a closed door, or a thermal fuse | Meter the latch and fuse, adjust or replace the strike, check board inputs |
| Dishes come out dirty | Wash pump weakened, spray arm blocked, or heater not reaching temperature; rarely hard water here | Watch the arms spin, meter the pump and heater, correct detergent dosing |
| Water left in the tub | Drain pump, check valve, or a drain hose routed wrong under a compact counter | Clear and meter the drain path, correct the hose loop, confirm the drain |
Book dishwasher service in Daniel Island → · Full dishwasher repair page →
$99 diagnostic, inside the repair · up to $20 off online
On the inverter refrigerators common in Daniel Island kitchens the ice maker answers to the main board, so an ice maker that goes silent can be the first sign of a board problem, or simply a worn module or weak fill valve. Our work is the ice maker inside the refrigerator; under-counter machines are not. Freezer temperature first, then a forced harvest, then the meter on the valve, module and board signal. One written number; the $99 diagnostic is inside it.
| What you notice | What it usually is | What we do |
|---|---|---|
| No ice, no sound | Module failed, main board not calling for a cycle, or a freezer running too warm to trigger a harvest | Confirm the freezer is cold enough, run a forced harvest, meter the module and the board’s call for ice |
| Hollow or small cubes | Weak inlet valve, overdue filter, or a pinched line behind a built-in refrigerator | Measure fill volume, test the valve under pressure, check the line route |
| Fill tube frozen | Valve dripping after fill, tube heater failed, or humid air past a door gasket | Clear the ice from the tube, meter the valve for a full close, inspect the gasket |
Book ice maker service in Daniel Island → · Full ice maker repair page →
Home base · ZIP 29407 · 29414
City page →15 min from the shop · ZIP 29412
City page →15 min from the shop · ZIP 29455
City page →15 min from the shop · ZIP 29401 · 29403
City page →20 min from the shop · ZIP 29405 · 29406 · 29418 · 29420
City page →25 min from the shop · ZIP 29464 · 29466
City page →30 minutes from the shop, no distance surcharge. up to $20 off the repair when you book online.